Usb Device Id Vid 1e3d Pid 198a ((better)) ★ Full HD
Developers creating software that interacts with USB devices use VID and PID to identify and communicate with specific devices.
Devices with this ID usually pack a Chipsbank CBM2199E or CBM2098E microchip inside.
This write-up covers the technical identity and common association for the USB Device ID VID 1E3D PID 198A Device Identification The combination of
Devices with this hardware ID are often white-label, generic, or promotional USB drives. Usb Device Id Vid 1e3d Pid 198a
I couldn't find any publicly available technical specifications for the device with VID 1e3d and PID 198a. However, here are some general technical specifications that might be relevant:
This mismatch between the reported and actual capacity means the device is likely a "fake." Using such a drive can lead to data loss or corruption when you attempt to write more data than the physical hardware can store.
Cheap USB drives often use recycled or low-quality NAND flash chips. When the flash memory degrades, the controller may still enumerate (show VID/PID) but fails to respond to read/write commands. This leads to “Unknown USB Device (Device Descriptor Request Failed)” or “The device is not migrated” errors. Developers creating software that interacts with USB devices
Below is a technical reference sheet and troubleshooting guide generated for this specific hardware profile. 🏷️ Device Identification
The hardware identifier represents a USB mass storage device, specifically a flash drive manufactured by Chipsbank Microelectronics Co., Ltd. .
The Product ID corresponds to the Chipsbank CBM2099 series of USB mass-storage controllers. More precisely, PID 198A is often associated with the CBM2099E or CBM2099S variant. When the flash memory degrades, the controller may
When you plug in a device, the operating system reads this combination to load the correct driver. If the VID/PID pair is altered or generic, it can cause connection and performance issues. The hardware ID for this device in Windows is often displayed as USB\VID_1E3D&PID_198A , following the standard format defined by Microsoft.
Chipsbank Microelectronics Co., Ltd. (commonly associated with USB flash drive controllers)
In some cases, a malfunctioning USB controller, corrupted EEPROM, or bad driver installation can cause a generic USB device to report 1E3D:198A incorrectly. If you have never seen this device before and it suddenly appears, run a hardware scan.
Yes, if properly formatted. But many gaming consoles reject Chipsbank controllers due to non-standard timing. If your console says “Unsupported USB device,” the drive is incompatible regardless of formatting.
