Once filtered, the AC voltage passes through a bridge rectifier to become pulsating DC.
The schematic will label the windings:
Following the safety filter, the smoothed AC waveform encounters a high-current . This converts the alternating sine wave into a pulsating, rough DC voltage. A smoothing filter capacitor establishes the initial high-voltage raw DC bus line. 3. Power Factor Correction (PFC) Circuit
: The unit is rated to provide 12V DC at approximately 16 Amperes .
If your ADP-200ER is dead, visual inspections and multimeter diagnostics usually reveal one of these common failure modes:
Most schematics will be divided into four functional blocks:
~200W sustained output capacity Circuit Blocks Architecture
The ADP-200ER architecture is generally divided into the following major functional blocks:
The PSU architecture is divided into several critical stages for power conversion and protection:
: Power supplies contain high-voltage capacitors that can hold a lethal charge even after the unit is unplugged. Always discharge capacitors before attempting any repairs.
Converts the filtered AC sine wave into a bumpy, rectified DC voltage.
Protects against overvoltage surges. NTC Resistor: Limits inrush current. Bridge Rectifier: Converts AC voltage into raw DC voltage. B. PFC (Power Factor Correction) Stage
Please check your cart to ensure you are purchasing a license for the correct version of InDesign. For alternative versions, please visit our webstore.
The totals below include sales tax at the applicable rate. To remove tax for exempt organisations, please enter a valid VAT number on the checkout screen.