Simrad Rf300 Installation Manual

The RF300 is designed to be mounted close to the rudder, ensuring the transmitter rod is perfectly aligned with the rudder's movement. 3.1 Choosing the Location

Locate a flat, rigid structural member or bulkhead near the rudder quadrant or tiller arm. Place the RF300 unit on the mounting surface.

:

Solid, comprehensive guide held back by a few technical leaps

The distance from the center of the rudder post to the link attachment point on the tiller arm must be exactly equal to the distance from the center of the RF300 shaft to its link attachment point. This standard distance is typically 140 mm (5.5 inches) . simrad rf300 installation manual

Despite careful installation, issues may arise with the RF300 system. Consult the troubleshooting guide in the Simrad RF300 installation manual for common problems and solutions.

Attach the ball joint to the rudder tiller arm at the 140 mm radius point. The RF300 is designed to be mounted close

Manually move the rudder to the maximum Port and Starboard positions as requested by the system to set the physical limits. Verification

: Fasten the other end of the transmitter rod to the RF300's transmitter lever. Use the two available slots in the lever to optimize the linkage if needed. : Solid, comprehensive guide held back by a