V2000-c Rfid Access Control User Manual

Once the system is installed and programmed, it is ready for daily use. Here is a summary of how different components behave during normal operation.

I can provide a custom wiring diagram step or exact programming sequences for your specific setup. Share public link

Press and hold down the # key (or the reset button located on the back PCB, depending on production batch). the device while continuing to hold the key. Release the key after hearing a series of short beeps.

To adjust how long the door remains unlocked (0-99 seconds): Enter Programming Mode. Press 4 + [0-99] + # . (Default is 5 seconds). Access Mode Configuration You can choose how users authenticate: Press 3 + 0 + # Card OR PIN: Press 3 + 1 + # (Default) Card + PIN: Press 3 + 2 + # 6. Resetting to Factory Defaults

The V2000-C RFID access control system comes with a comprehensive user manual that provides detailed instructions on installation, configuration, and operation. Here are some key configuration steps: V2000-c Rfid Access Control User Manual

Connect a standard normally open push button between the PUSH and GND terminals. 3. Programming and Configuration Guide

A: 500 users (500 RFID cards or 500 PIN codes, or a mix).

This guide provides a comprehensive overview of the , designed to assist with installation, programming, and troubleshooting of this popular security device . The V2000-c is a stand-alone RFID proximity access control unit, widely used for enhancing security in office buildings, apartments, and residential properties. V2000-C RFID Access Control Overview

Before mounting or wiring the unit, ensure your installation environment meets the physical and electrical operating criteria of the V2000-c keypad: Specification Up to 2,000 users (Cards/PINs) Operating Voltage 12VDC ±10% (Supports 24VAC systems on select variants) Card Read Type 125kHz EM (Identification) / Proximity Cards Card Read Distance Card Read Speed Less than 0.1 seconds Relay Output Load Max 3A (Supports Fail-Secure and Fail-Safe locks) Interface Input/Output Wiegand 26 (Can function as an external reader) Built-in Security Tamper switch sensor and door status alarm Installation and Wiring Diagram Physical setup of the Go to product viewer dialog for this item. Once the system is installed and programmed, it

For data security, change the default code immediately upon deployment: Enter Programming Mode ( * + 990101 + # ). Press 0 . Enter your , then press # .

: Relay Normally Closed (NC) – Connects to Fail-Safe locks (Magnetic Locks) YELLOW : Open Button (PUSH) – Connects to the exit button

Proper installation requires understanding the terminal block connections on the back of the V2000-C unit. Before wiring, always disconnect the 12V DC power supply to prevent short circuits. Terminal Definitions Positive power input (12V DC) GND (Black): Negative power input / Ground reference PUSH (Yellow): Low-level trigger input for exit buttons OPEN (Green): High-level trigger or door switch loop

💡 Presenting a card immediately after 11 or 13 is often easier than typing card number. Share public link Press and hold down the

The V2000-C RFID Access Control system is a standalone device supporting up to 2,000 users with card-only, PIN-only, or combined verification modes for single-door security. It features a stainless steel design, 12V DC power requirements, and supports Wiegand 26-bit interfacing for integration. Detailed instructions for installation and user enrollment can be found in the savebase.com manual www.goldbridgesz.com

The V2000-C RFID access control system is a compact, 2,000-user device praised for stable performance, though users often find its programming manual complex. It supports multiple entry modes, including card-only, PIN-only, or card-and-PIN combinations. Detailed information and user experiences with the device can be found on JustAnswer .

The V2000-c uses a star-prefix command structure. [Master Code] + [#] .