Cem Dual Mig 120 Manual

Usually supports 0.023" (0.6mm) to 0.035" (0.9mm) wire. 3. Setup Instructions (From the CEM MIG 120 Manual)

This potentiometer controls how fast the motor pushes the wire. This must be tuned by ear—you’re looking for a consistent "sizzling bacon" sound. cem dual mig 120 manual

Unclog liner; back off drive roller pressure; ensure tip matches wire diameter exactly. Usually supports 0

Many experienced welders try to “figure it out” without reading the manual. With the CEM Dual MIG 120, that is a mistake. This is a dual-voltage machine (110V and 220V capability in some models, though standard is often 230V single-phase), and incorrect voltage setup can lead to catastrophic failure. This must be tuned by ear—you’re looking for

Protect your skin from UV radiation burns using leather welding gloves and a flame-resistant jacket.

The front panel of the CEM Dual MIG 120 features straightforward controls designed for quick adjustments.

Ensure the drive roller groove matches your wire size (0.6mm or 0.8mm). Most rollers can be flipped around to switch groove sizes.